Yukon 26126T Manual de instrucciones descargar pdf (Pagina 3)

• Regular maintenance of the scope will help keep the device free from malfunctions and

untimely wearing of parts and connectors.

Failure to observe these warnings will void the manufacturer's warranty

BATTERY INSTALLATION

• Turn the knob of the battery compartment cover 90º counterclockwise (1) to match the red dot

on the knob with the red dot on the battery compartment cover.

• Remove the cover by raising it by its lug.

• Slide in two АА batteries so that the “+” and “-” match the polarity on the inner side of the

cover; rechargeable AA batteries may be used.

• Close the cover of the battery compartment cover and turn the knob of the cover 90º

clockwise.

OPERATING THE SENTINEL G2+

WARNING: It is strongly recommended to test and operate the Sentinel G2+ in dark

conditions or at night time.

• Install the batteries according to the directions in the section entitled “BATTERY

INSTALLATION”.

• Enter a dark environment.

• Remove the objective lens cap by sliding it up on top of the objective lens (2).

• Activate the scope by turning the power switch to the “ON” position (3).

• Select the color of the reticle, green or red, by pushing the button (5) until its clicking position.

• Adjust the reticle brightness by rotating the switch (4).

• Please select an object of observation at a distance of approximately 100 meters (about 110

yards) away.

• Set up the objective focus ring knob (6) to be aligned with the mark "100".

• Focus on the selected object by rotating the eyepiece ring (7). If needed, turn on the IR

illuminator (8) by turning the switcher (3) to the “IR” position.

• Rotate the IR illuminator lens ring - by doing so it moves forwards and backwards - until the IR

illuminator beam is focused (picture quality turns worse if the luminance level is excessive). If

1 2 3 4 5 6 7 8 9

Sin comentarios

Yukon 26126T Manual de instrucciones Pagina 3